Ozone in Cosmetology
We are pleased to present you the following
high-effective methods of using ozone in cosmetology:
For the start
we would recommend you the method of nonsurgical
liposuction, which has proved to be clinically high-effective and returns
the invested money in a short time.
To realize
this method you will need a medical ozone generator (which can be equipped with
a built-in low-flow unit designed particularly for multi-injectory method),
pumping unit, disposable syringes 20, 60 ml, multi-injectors for 3, 5, 7
needles, thin needles (28G), ozonized anticellulites gel or oil. One treatment
course consists of 6–12 procedures 1-2 times a week. Before the basic treatment
it is recommended to perform a preparatory vacuum-vibratory massage with
ozonized oil or gel (the “problem” area is prepared for subcutaneous injections,
at the same time, owing to the analgesic effect of ozone the threshold of pain
sensitivity is reduced), then the ozone-oxygen mixture is injected into the
cellulites area through single thin needles or by means of multi-injectors
according to the definite schema. After the introduction of gas mixture the area
should be carefully massaged for equal distribution of gas mixture in
subcutaneous cell tissue.
|
Vacuum-vibratory massage by ozonized olive oil
(gel) |
Injections of ozone-oxygen mixture (through single
needles) |
Low-flow multi-injectory method |
|
In
contrast to injections of ozone-oxygen mixture through single needles,
the low-flow multi-injectory method is performed as follows: the
special outlet of ozone generator is connected to the multi-injector
(the so-called “comb”) for 3 – 5 - 7 exits attached to connection hoses
fitted with thin needles to be applied subcutaneously to a “problem”
area. As a result, the ozone-oxygen mixture is supplied to the
cellulites area directly from the apparatus at stably low flow-rate
(less than 2 ml/min), during the procedure it is equally distributed
through intercellular space of the problem area.
|
Thanks to the low flow rate and supply equality, the procedure is
atraumatic, efficient and painless, popular among both doctors and
patients. According to the above-mentioned, it requires an ozone
generator with a built-in ozone-oxygen low-flow unit (at the same time,
this ozone generator can operate at its usual mode as well). |
The
therapeutic effect of ozone in cellulites is produced through different mechanisms of action.
Ozone reacts with the double bonds of the unsaturated fatty acids by modifying
their properties that results in the break-down of lipid chain, the hydrophobic
lipids are converted into the less stable hydrophilic compounds.
Thanks to the properties to improve micro-circulation, to increase the
capacity of the erythrocytes to transport oxygen to tissues as well as the
fibrolitic effect, ozone facilitates the resorption of the part of connective
tissue structures surrounding the adipocyte that normalizes fat cell
metabolism.
The introduction of ozone improves the course of cellulites at any
stage. In order to determine the efficiency and tolerance of ozone therapy in
comparison with the traditional methods of treatment for cellulites and local
lipodystrophy, the physicians of the Russian Association of Ozonetherapy
conducted a great number of investigations including the measurement of the area
of damaged surfaces and local temperature with consideration of general clinical
picture and came to a conclusion that ozone-oxygen therapy is significantly more
effective than the traditional well-known methods of treatment for cellulites
(the effect is noticeable already after first procedures) and complies with all
the actual medical requirements for safety and efficiency of the treatment.